toggle quoted messageShow quoted text
When I first noticed the say all issue I did send a copy of my log file to an NVDA developer/contributor and he/she told me that there were buffering issues but that it would be taken care of at some point and that there were others issues that are more important and were being looked at first!
So, I just rolled back to NVDA 2019.2.1 until the RC version of NVDA 2019.3/2020.1 comes out!
On 1/5/2020 7:39 AM, Rui Fontes wrote:
Hello Carlos and Bryan Mckinnish!
Make such affirmation without sending a NVDA log is not very clever since lots of users, including myself, are using 2019.3 in Beta or Alpha versions and continuous reading works as ever...
So, please do the following:
1 - Run NVDA with add-ons disabled;
2 - If SayAll it is yet not working as it should, restart NVDA with the log enabled;
3 - Get the log and send us. Be aware that the log will show your passwords, so clean the log file of that...
NVDA portuguese team
De: email@example.com <firstname.lastname@example.org> Em Nome De Carlos
Enviada: domingo, 5 de janeiro de 2020 13:52
Assunto: Re: [nvda] say all not working in nvda beta
Yesterday I commented on this issue and one of the moderators decided to shoot me down!
I was using NVDA 2019.3beta and I had to roll back to NVDA 2019.2.1 for these reasons that others are having with say all on it seems to happen on any program that uses say all command!
Just remember that moderators pay attention to these posts and if it sounds negative to them you will get a stern talking to like I did!
Hope that the RC version of NVDA 2019.3 will have these buffering issues fixed?
On 1/5/2020 4:57 AM, Bryan Mckinnish wrote:
I upgraded to the nvda 2019.3 beta yesterday, all is going well so
far, but I ran into a little problem.
I'm trying to read a document in notepad, and the say all command only
seems to read the line that the cursor is on.
Is anyone else experiencing this?
Carlos - Windows 10 Home, 64 Bit, Version 1909, Build 18363 - NVDA Version 2019.2