Re: say all not working in nvda beta


I'm not having any trouble with the say all command, however, as Gene
pointed out you should try both the laptop and desktop commands as on
an earlier version update my "insert key plus down arrow" switched to
the "caps lock plus down arrow" on it's own. Switching it back
quickly fixed my issue, hope it works for you too.


On 1/5/20, Gene <> wrote:
I didn't see anyone shoot you down on the list. If you are referring to my
message, I didn't shoot you down. I asked for more information and I said
that since the beta has been out for two weeks or longer, the proboem may be
specific to your system.
If that is what you are referring to, that isn't shooting anyone down. You
asked for help and I answered telling you what I suspect and asking for more

I didn't say you didn't have a problem, I don't know. I said it may be
specific to your machine.

And I am not a moderator. I was a moderator.

----- Original Message -----

From: Carlos
Sent: Sunday, January 05, 2020 7:51 AM
Subject: Re: [nvda] say all not working in nvda beta


Yesterday I commented on this issue and one of the moderators
decided to shoot me down!

I was using NVDA 2019.3beta and I had to roll back to NVDA 2019.2.1
for these reasons that others are having with say all on it seems to
happen on any program that uses say all command!

Just remember that moderators pay attention to these posts and if
it sounds negative to them you will get a stern talking to like I did!

Hope that the RC version of NVDA 2019.3 will have these buffering
issues fixed?

On 1/5/2020 4:57 AM, Bryan Mckinnish wrote:

I upgraded to the nvda 2019.3 beta yesterday, all is going well so
far, but I ran into a little problem.

I'm trying to read a document in notepad, and the say all command only
seems to read the line that the cursor is on.

Is anyone else experiencing this?


Bryan Mckinnish

Carlos - Windows 10 Home, 64 Bit, Version 1909, Build 18363 - NVDA Version

Join to automatically receive all group messages.