toggle quoted messageShow quoted text
No you do not have to listen to all of it first as long as when
you open the about section it starts to read press the ctrl key.
Check which keyboard layout you are using press the nvda key +
ctrl key + the letter K.
It will open the keyboard settings it should land on your
Mine speaks desktop so then you just close it
If you already know the keyboard layout miss the above step.
Make sure you are in object navigation mode first use the nvda key
+ number 1 on the numeric keypad to do this I am not sure what it
is for the laptop version I would have to look it up I think it is
So if you are hopefully still on the about button in my case I
would use the nvda key + 8 on the numeric keypad to go up a level
or the laptop command if in that layout.
Then I would use the number 7 on the numeric keypad to get me to
the top of the document or in this case the about section.
The rest of the numbers used as mentioned before is how you read
it the text review commands is for read only sections like this.
On 20/10/2021 10:12 am, Lexi wrote:
Thank you for the explanation. Unfortunately, it
didn't work for me. I am using a laptop but I have a keyboard
connected to it. Do I have to listen to all of the information
play through before I can do it?
The easiest way if it is on the about button is when
you open it in my case I use object navigation.
It will read out the information and you can not
interact with it so I do the following
I am using a desk top after it has read out the
information I use object navigation in this case it is
the nvda key+ number 8 on the numeric keypad. It takes
me up a level to where the information is.
Then I can use the number 7 on the numeric keypad to
take me up to the top line which is previous line to I
get to top.
I can use the number 9 on the numeric key pad to read
down a line
4 will do previous word and 6 next word.
1 is previous character and 3 is next character.
8 is current line, 5 is the word you are on and 2 is
the character you are on.
Depending how you read it I might read the whole lot
then do it word by word say for example.
You might have to look up the command to go up a level
in object navigation if using a lap top.
hope it helps.
On 20/10/2021 9:42 am, Lexi wrote:
Hello everyone, when I go into
the NVDA menu, and click on manage add-ons, and I go to
about add-on, it reads all the information all at once.
Does anyone know of a way to slow this down? Reading it
by words, lines, and characters doesn't work. I only
need a little bit of information, and that's at the end
of all of the information that it gives me.--
be blessed and be safe. Thank you,
Please be blessed and be safe.