toggle quoted messageShow quoted text
Is the num lock key off if it is on you will only hear numbers
Make sure it is off.
If when you open the about button then press the ctrl key to make
him or her quite you must then use the object navigation key given
before for your layout
Make sure you change into it first with the nvda key + 1 on the
numeric keypad you should hear it spoken.
Mine was nvda key + 8 on the numeric keypad.
This takes me up a leve to where the text is.
Then after that you used the review cursor commands as the ones
for a desk top are different to a lap top user.
Make sure you go to the top of the document then the commands to
read it for your layout.
On 20/10/2021 10:37 am, Lexi wrote:
Hi, even after switching my layout to desktop,
those numpad commands didn't work for me. They don't say
anything. I don't know if I'm doing something wrong or what.
No you do not have to listen to all of it first as long
as when you open the about section it starts to read
press the ctrl key.
Check which keyboard layout you are using press the
nvda key + ctrl key + the letter K.
It will open the keyboard settings it should land on
your keyboard layout.
Mine speaks desktop so then you just close it
If you already know the keyboard layout miss the above
Make sure you are in object navigation mode first use
the nvda key + number 1 on the numeric keypad to do this
I am not sure what it is for the laptop version I would
have to look it up I think it is the same.
So if you are hopefully still on the about button in my
case I would use the nvda key + 8 on the numeric keypad
to go up a level or the laptop command if in that
Then I would use the number 7 on the numeric keypad to
get me to the top of the document or in this case the
The rest of the numbers used as mentioned before is how
you read it the text review commands is for read only
sections like this.
On 20/10/2021 10:12 am, Lexi wrote:
Thank you for the explanation.
Unfortunately, it didn't work for me. I am using a
laptop but I have a keyboard connected to it. Do I
have to listen to all of the information play through
before I can do it?
The easiest way if it is on the about button
is when you open it in my case I use object
It will read out the information and you can
not interact with it so I do the following
I am using a desk top after it has read out
the information I use object navigation in
this case it is the nvda key+ number 8 on the
numeric keypad. It takes me up a level to
where the information is.
Then I can use the number 7 on the numeric
keypad to take me up to the top line which is
previous line to I get to top.
I can use the number 9 on the numeric key pad
to read down a line
4 will do previous word and 6 next word.
1 is previous character and 3 is next
8 is current line, 5 is the word you are on
and 2 is the character you are on.
Depending how you read it I might read the
whole lot then do it word by word say for
You might have to look up the command to go
up a level in object navigation if using a lap
hope it helps.
On 20/10/2021 9:42 am, Lexi wrote:
Hello everyone, when I
go into the NVDA menu, and click on manage
add-ons, and I go to about add-on, it reads
all the information all at once. Does anyone
know of a way to slow this down? Reading it by
words, lines, and characters doesn't work. I
only need a little bit of information, and
that's at the end of all of the information
that it gives me.--
blessed and be safe. Thank you,
be blessed and be safe. Thank you,
Please be blessed and be safe.